AN ANALYSIS OF THE PROPERTIES OF CHROMIUM - BASED COATINGS DEPOSITED BY TIG WELDING

1 DUDEK Dominik
Co-authors:
1 STEFAŃCZYK Konrad 2 SKOWRON Ewelina
Institutions:
1 Kielce University of Technology, Kielce, Poland, EU, dominik_dudek@op.pl
2 Mesko S.A., Skarżysko-Kamienna, Poland, EU
Conference:
26th International Conference on Metallurgy and Materials, Hotel Voronez I, Brno, Czech Republic, EU, May 24th - 26th 2017
Proceedings:
Proceedings 26th International Conference on Metallurgy and Materials
Pages:
1246-1251
ISBN:
978-80-87294-79-6
ISSN:
2694-9296
Published:
9th January 2018
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
389 views / 164 downloads
Abstract

The paper deals with the investigations which consisted in conducting the process of hardfacing of steel sheets from X10CrMoNb9-1 steel. There were two different coatings marked to sheets through the TIG method. The material used on the weld overlay was as follows: W CrMo2Si, W CrMo91. After hardfacing of steel sheets, the examined samples have been cut from the sheets, from which the metallographic samples have been produced. In the paper, there were photographs of microstructures of metallographic samples attached, which were taken during the microscopic observations. The observations using optical microscope Nicon Eclipse MA 200 compared changes in surface microstructure and the effect of TIG welding. The process of hardfacing was conducted on the Electric Invertec V270 device - T pulse.

Keywords: Superficial layer, hardfacing, coating, TIG welding, microstructure

© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Scroll to Top