EVALUATION OF CHOSEN PARAMETERS OF SURFACE ROUGHNESS (MICROGEOMETRY) ON THE SAMPLES FROM STAINLESS STEEL 316L AND MANUFACTURED BY THE ADDITIVE TECHNOLOGY SLM

1 PAGÁČ Marek
Co-authors:
1 MALOTOVÁ Šárka 1 ZLÁMAL Tomáš 1 PETRŮ Jana 1 KRATOCHVÍL Jiří
Institution:
1 VSB - Technical University of Ostrava, Ostrava, Czech Republic, EU
Conference:
26th International Conference on Metallurgy and Materials, Hotel Voronez I, Brno, Czech Republic, EU, May 24th - 26th 2017
Proceedings:
Proceedings 26th International Conference on Metallurgy and Materials
Pages:
956-961
ISBN:
978-80-87294-79-6
ISSN:
2694-9296
Published:
9th January 2018
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
437 views / 311 downloads
Abstract

The article deals with the evaluation of chosen parameters of surface roughness on the square section samples from stainless steel 316L (1.4404), manufactured by the additive technology with using Selective Laser Melting method (SLM). As part of the experiment was measured (scanned) and compared of chosen parameters of surface roughness on plane area of the samples printed in the same process parameters with a difference of power of the laser. One set of samples was printed during half power machine (200 W), the second during maximum power (400 W). The samples were oriented in the building chamber in the same way. The plane areas of blocks were parallel with plane XZ and YZ of coordinate system of 3D printer Renishaw AM400. The measuring of parameters of surface roughness was evaluated by optical microscope Alicona Infinite Focus5.

Keywords: Keywords: 3D printing; Additive Technology; Renishaw; Surface Roughness; Alicona microscope.

© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Scroll to Top