COMPARISON OF PROPERTIES OF STEEL 100CR6 AND C56E2 IN THE PROCESS OF MACHINING

1 STANČEKOVÁ Dana
Co-authors:
1 KAMENÍK Roman 1 SAPIETOVÁ Alžbeta 1 PILC Jozef 2 ZLÁMAL Tomáš 3 CAIS Jaromír
Institutions:
1 University of Zilina, Univerzitna 1, Zilina 010 26, Slovakia, EU
2 VSB - Technical University of Ostrava, Ostrava, Czech Republic, EU
3 Univerzita Jana Evangelisty Purkyne v Usti nad Labem, Czech Republic, EU
Conference:
26th International Conference on Metallurgy and Materials, Hotel Voronez I, Brno, Czech Republic, EU, May 24th - 26th 2017
Proceedings:
Proceedings 26th International Conference on Metallurgy and Materials
Pages:
819-825
ISBN:
978-80-87294-79-6
ISSN:
2694-9296
Published:
9th January 2018
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
553 views / 707 downloads
Abstract

A use of selected steels in the industrial practice is very important and frequent and this is the reason why it is necessary to know their qualities not only from the standpoint of material, but also regarding its machinability with the aim to gain a product of a fine quality in optimal economic conditions. Machinability was compared in cases of steel 100Cr6 and steel C56E2 directly in the production process by means of experimental verification of deterioration of cutting materials, measurements of dynamics of a cutting process, evaluation of macrostructure and quality of surface layers.

Keywords: Steels, properties, machinability, verification

© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Scroll to Top