INCREASING THE QUALITY OF DC01 STEEL BY DRECE METHOD

1 RUSZ Stanislav
Co-authors:
1 KRAUS Martin 1 HILŠER Ondřej 1 Švec Jiří 1 Kedroň Jan 1 ČÍŽEK Lubomír 2 Donič Tibor 3 TAŃSKI Tomasz 1 Krejčí Lucie
Institutions:
1 VŠB-Technical University of Ostrava, 17. listopadu 15, CZ 708 33 Ostrava, Czech Republic
2 University of Žilina, Univerzitna 1, Sk 010 26 Žilina, Slovakia
3 Silesian University of Technology, Konarskiego 18a St., 44-100 Gliwic, Poland
Conference:
26th International Conference on Metallurgy and Materials, Hotel Voronez I, Brno, Czech Republic, EU, May 24th - 26th 2017
Proceedings:
Proceedings 26th International Conference on Metallurgy and Materials
Pages:
527-532
ISBN:
978-80-87294-79-6
ISSN:
2694-9296
Published:
9th January 2018
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
544 views / 486 downloads
Abstract

Development of production technology of very fine-grained material is currently very intensively accelerated. Even in scientific research, it is recognized that precisely controlled forming processes, including special processes, enabling control of technological parameters with regard to the structure and its further refinement, currently has the highest gradient utilization efficiency of scientific research findings into practice. Besides the methods C2S2 and ARB for sheet metal forming, in terms of industrial practice intensively develop new technologies, to which also belongs Dual Rolling Equal Channel Extrusion (DRECE) method. Forming device that uses the method in question is currently being installed at the workplace in Centre of Advanced Innovation Technologies, VSB Technical university of Ostrava. Experimentally were verified steel DC 01- strip sheet with dimensions 58 (width) x 2 (thickness) x 2 000 (length) mm. The paper evaluated the influence of severe plastic deformation (SPD) on the quality this steel at sizes angle forming tool 108°. In the present work are solved structural characteristics of carbon steel DC01 after application DRECE method, including an assessment of basic mechanical properties, that are important for application scientific research findings into practice.

Keywords: Severe plastic deformation, DRECE method, forming tool, steel DC01, structure and mechanical properties

© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Scroll to Top