THE INFLUENCE OF LI, CA CONTENT ON THE MICROSTRUCTURE AND PROPERTIES OF MG-LI-CA ALLOYS AFTER EXTRUSION PROCESS

1 BEDNARCZYK Iwona
Institution:
1 Silesian University of Technology, Faculty of Materials Engineering and Metallurgy 40-019 Katowice, Poland, iwona.bednarczyk@polsl.pl
Conference:
27th International Conference on Metallurgy and Materials, Hotel Voronez I, Brno, Czech Republic, EU, May 23rd - 25th 2018
Proceedings:
Proceedings 27th International Conference on Metallurgy and Materials
Pages:
1466-1471
ISBN:
978-80-87294-84-0
ISSN:
2694-9296
Published:
24th October 2018
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
466 views / 194 downloads
Abstract

The article presents tests results of the influence of Li and Ca content on the microstructure and properties of Mg-4Li-1Ca (LX41) and Mg-8Li-2Ca (LX82) alloys after extrusion process. Achieved microstructures of magnesium alloys after extrusion were compared with microstructure after casting and homogenisation. An analysis was conducted of the microstructure in initial condition and in condition after plastic deformation with the use of techniques of light and scanning microscopy. Presented results show the mechanical properties marked in static extrusion test in room temperature. It was stated that alloy Mg-4Li-1Ca (LX41) is characterised with better plasticity than the alloy Mg-8Li-2Ca (LX82).

Keywords: Mg-Li-Ca alloys, microstructure, extrusion process, electron microscopy, static compression test

© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Scroll to Top