EFFECT OF AUSTEMPERING PARAMETERS ON MICROSTRUCTURE OF ADI WITH 1.5% NI WPŁYW PARAMETRÓW HARTOWANIA IZOTERMICZNEGO NA MIKROSTRUKTURĘ ŻELIWA ADI Z DODATKIEM 1,5% NI
1 OLEJARCZYK-WOŻEŃSKA Izabela
Co-authors:
1 MRZYGŁÓD Barbara
3 GIĘTKA Tomasz
2 KOWALSKI Adam
1 Henryk Adrian
Institutions:
1 AGH University of Science and Technology, Faculty of Metals Engineering and Industrial Computer Science, al. A. Mickiewicza 30, 30-059 Cracow, Poland, EU,
iolejarc@agh.edu.pl
2 Foundry Research Institute, ul. Zakopiańska 73, 30-418 Cracow, Poland, EU
3 UTP University of Technology and Life Sciences, Faculty of Mechanical Engineering, Al. prof. S. Kaliskiego 7, 85-796 Bydgoszcz, Poland, EU
Proceedings:
Proceedings 26th International Conference on Metallurgy and Materials
Published:
9th January 2018
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
311 views / 152 downloads
Abstract
Ductile iron with 1.56% Ni was subjected to various cycles of the austempering treatment. For all variants, the austenitization temperature was 920oC and the time of holding was 2 hours. Austempering was carried out at temperatures of 260, 300, 330, 360, 380, 400oC with the time of 15, 30, 60, 90, 120 and 150 minutes. After each variant, the microstructure of the metal matrix was examined. Measurements covered hardness of the matrix and microhardness of "acicular" ferrite, austenite and martensite
Keywords: Ductile iron, heat treatment, the microstructure of ADI, ADI properties
© This is an open access article distributed under the
Creative Commons Attribution License
which permits unrestricted use, distribution, and reproduction in any medium, provided the original work
is properly cited.