IMPLEMENTATION OF COATING FOR FAILURE ELIMINATION OF DIAL GAUGES

1 STANCEKOVA Dana
Co-authors:
1 SAJGALIK Michal 2 PETRU Jana 3 NAPRSTKOVA Natasa 1 BALAZ Pavol
Institutions:
1 University of Zilina, Zilina, Slovakia, EU
2 VSB - Technical University of Ostrava, Ostrava, Czech Republic, EU, jana.petru@vsb.cz.
3 Jan Evangelista Purkyne University in Usti nad Labem, Czech Republic, EU
Conference:
24th International Conference on Metallurgy and Materials, Hotel Voronez I, Brno, Czech Republic, EU, June 3rd - 5th 2015
Proceedings:
Proceedings 24th International Conference on Metallurgy and Materials
Pages:
1162-1169
ISBN:
978-80-87294-58-1
ISSN:
2694-9296
Published:
12th January 2015
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
126 views / 35 downloads
Abstract

One of very important requirements for measuring devices is fact that measured values of observed quantity will be in specific tolerance zone of actual value also after longer period of use. Deviations of actual value can be caused by several factors – improper handling with devices, inadequate maintenance and storing, aging of materials of which they are made and last but not least, by wear of single parts.The target was to define the way of wear elimination of most faulty parts of dial gauges to obtain the maximum possible lifetime with minimal possible costs. Since, the using of more resistant material for producing of faulty part is difficult economically, for eliminating of wear, there was used the coating method for given part. By experimental results, it was choosen suitable way of coating.

Keywords: Coating, measuring devices, elimination of wear, lifetime

© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Scroll to Top