NUMERICAL AND EXPERIMENTAL FORMING OF AXISYMMETRIC PRODUCTS USING FLOW FORMING METHOD FOR HARD-TO-DEFORM MATERIAL

1 WOŹNIAK Dawid
Co-authors:
1 HOJNY Marcin 1 GŁOWACKI Mirosław 2 GĄDEK Tomasz
Institutions:
1 AGH University of Science and Technology, Cracow, Poland, EU, dwozniak@agh.edu.pl
2 Metal Forming Institute, Poznan, Poland, EU
Conference:
24th International Conference on Metallurgy and Materials, Hotel Voronez I, Brno, Czech Republic, EU, June 3rd - 5th 2015
Proceedings:
Proceedings 24th International Conference on Metallurgy and Materials
Pages:
452-457
ISBN:
978-80-87294-58-1
ISSN:
2694-9296
Published:
12th January 2015
Proceedings of the conference were published in Web of Science and Scopus.
Metrics:
335 views / 113 downloads
Abstract

This article is devoted to the problem of forming of axisymmetric elements of hard-to-deform material. The first stage was the deep drawing process of metal discs. Then the blanks were formed by the method of flow forming. The use of modern computer technology has become an integral part of the development of innovative flow forming technologies. The use of software tools in the forming of numerical analysis systems based on the finite element method speeds up the design and optimization of processes.

Keywords: Flow forming, FEM modeling, hard-to-deform material

© This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Scroll to Top